1. Help
  2. Wallet Builder

Pocket cut-outs

A cut-out in a pocket’s top edge makes the card under it easier to push out. Select a pocket in the drawing, then pick a shape under Cut-out.

Pick a shape

  1. Click a pocket in the drawing. Shift-click more pockets to give them all the same cut-out.
  2. Under Cut-out, pick Round, V, U, Flat, Wave or Slant.
  3. Set its Width and Depth, or for Slant the Lower side and the Drop.

A slanted mouth drops in whole stitches, so no hole lands on its low corner. A cut-out never grows past what the pocket allows: it stays clear of the side stitching, and on a pocket behind another one it stays above the mouth of the pocket in front.

Pick None to take a cut-out away.

Draw your own

Pick Custom. A large view of the pocket’s top edge opens under the options, starting as a straight edge:

  • Press the edge to add a point, and drag it.
  • Drag a point to move it, and drag a small diamond to bend the edge next to it.
  • Double-click a point to remove it.
  • Click a point, or a small square where the cut-out leaves the straight edge, and set Rounding to round that corner.

Keep it in your library

Signed in, click Save to my library… and give the cut-out a name. It is then under From your library for any pocket of any wallet, and in the editor under Templates.

Change a saved cut-out later and choose to update it or to Save as new….

Something missing or unclear? Write to support@easypatt.com and it gets fixed.