- Help
- Drawing
Lines and outlines
Use Line for a single straight line and Multipoint line for an outline with as many corners as you need: a strap end, a tapered panel, a pocket with slanted sides.
Draw a line
Pick Line (L) and drag from one end to the other. The end lines up with the start and with other shapes as you go, and a label shows its length and angle.
Start or end a line on the side of a rectangle or on another line and it stays attached there: move or resize the rectangle and the line follows.
- Start and End
- Where its two ends are.
- Length
- Changes the length, keeping the middle where it is.
- Angle °
- Turns the line about its middle. 0° points to the right.
- Mode
- Straight, curved (a smooth bow) or elbow (a U-shaped step).
Curved and elbow lines
Select a line and pick the curved or the elbow button under Mode. A curved line bows out from the middle; drag its middle to change how far.
An elbow turns the line into a U-shaped step with square corners. Each straight piece has a small square handle in its middle: drag one sideways to add another step there. Set Corner radius to round the corners. This is a quick way to draw a stepped pocket or a tab.
A curved or elbow line shows its Total length under it.
Draw an outline point by point
- Pick Multipoint line (N).
- Click where each corner goes. A dashed side follows the mouse with its length and angle.
- Click the first point again to close the outline into a part. To leave it open, double-click the last point, or press Enter or Esc.
| Backspace | Take back the last point |
| Shift | Place a point without snapping |
| EnterorEsc | Finish an open line, keeping every point |
The result is one shape: stitch it, round its corners, bend its sides or mark it as a cutout like any other.
Something missing or unclear? Write to support@easypatt.com and it gets fixed.