1. Help
  2. Drawing

Changing an outline

Any part can be changed after it is drawn: drag its corners, bend one side into a curve, or add a corner where you need one.

Move a corner

Select an outline, a triangle or a polygon, and drag one of its corner points. A label shows the length of the two sides that meet there. Rectangle corners resize the rectangle instead.

  • Click a point without dragging to pick it: its X and Y then show in the panel, to type an exact position.
  • Shift-click several points, then drag one of them: they all move together, for example to lengthen a whole side.
  • A picked point snaps onto the corners and edges of other parts, so two parts can meet exactly.

Bend a side

  1. Select the part.
  2. Click one of its sides. Only that side is highlighted, with a blue dot in its middle.
  3. Drag the dot to bend the side into a curve. Drag it back onto the straight line to straighten it.

With a side picked, the Edge card at the top of the panel sets the curve exactly:

Position from start
Where along the side the curve is deepest.
Depth (+ outward)
How far the curve bows out. A negative depth bows it inward.
Straighten
Makes the side straight again.

Circles and curves made from them cannot bend their sides; draw an outline instead.

Add a corner point

Pick Add corner point (B), or click Add corner point in the panel. Press on a side where the new corner should go and drag it into place.

  • The new point makes a sharp corner; the two sides stay straight. Bend them afterwards if you want curves.
  • Near the middle of a side, the point snaps to the exact middle. Hold Shift to place it anywhere.
  • A rectangle becomes an outline, so its width, height and corner fields give way to its points. A circle becomes a curve with points.

Remove a point or a side

  • Pick a point and press Backspace: the two sides that met there become one straight side.
  • Pick a side and press Backspace: the outline opens there. A side in the middle of an open outline splits it in two.

Removing a side is how you open a closed outline, for example to leave the top of a pocket unstitched as a separate line.

Something missing or unclear? Write to support@easypatt.com and it gets fixed.