- Help
- Drawing
Rectangles, circles and polygons
Most parts start as a simple shape. Draw it roughly with the mouse, then type its exact size in the panel on the left.
Draw a shape
Pick a tool in the toolbar and drag on the canvas. When you let go, the new shape is selected and the toolbar goes back to Select.
- Rectangle (R)
- Drag from one corner to the opposite one.
- Circle (C)
- Drag from the centre outwards.
- Triangle (P)
- Drag a box: the base runs along its bottom and the tip sits at the top in the middle.
- Polygon (Y)
- Set the number of Sides in the panel first (3 to 24), then drag from the centre outwards. Every side is the same length, with one lying flat along the bottom.
Shapes snap to the grid and to the corners and centres of other shapes as you draw. See Grid and snapping.
Give it an exact size
With the shape selected, the Properties panel on the left shows its size. Type a number and press Enter, or click away.
- Position
- Where the shape is: for a rectangle or a triangle, its bottom-left corner. Y counts upwards.
- Size
- The width (W) and height (H). Tick Lock ratio to keep the proportions when you change one.
- Center and Radius
- For a circle.
- Rotation °
- Turns the shape, in whole degrees.
- Make equilateral
- For a triangle: keeps the base and puts the tip over its middle, so all three sides are the same.
- Sides and Side length
- For a polygon: change the number of sides, or the length of each side.
Boxes take sums and units too, such as 100/3 or 5 cm. See Exact sizes, sums and variables.
Round the corners
Select a rectangle and type the radius in Corners. The four boxes are laid out like the corners they round. While the link between them is on, one value rounds all four; click it to set each corner on its own.
You can also drag the small round handle just inside a corner of the selected shape. Triangles and outlines drawn point by point have one at each corner too.
A D-shaped card pocket is a rectangle with only two corners rounded.
Line colour and style
Under Stroke, set the Color and Width of the outline, and its Style: solid, dashed or dotted. The PDF prints it the same way.
The fourth style, a row of holes, only draws holes along the whole outline. For stitching you can set up and match between parts, use a stitch line.
Something missing or unclear? Write to support@easypatt.com and it gets fixed.