1. Help
  2. Leather features

Hardware

Hardware is drawn at its real size with its punch holes, so the printed pattern shows exactly where to punch and set it.

Place hardware

  1. Open the Hardware tab in the left panel.
  2. Click an item. It follows the mouse over the canvas.
  3. Click where it goes. It snaps to the corners, side middles and centres of parts, and lines up with guides.

Each click places one piece. To place another, pick the item again. Esc puts it away.

The hardware library

Snap line 20
Line 20 snap fastener, about 12.5 mm cap: one 4 mm hole.
Snap line 24
Line 24 snap fastener, about 15 mm cap: one 5 mm hole.
Press stud
About 10 mm cap: one 4 mm hole.
Rivet 6 mm
Double-cap rivet: one 2 mm hole.
Rivet 8 mm
Double-cap rivet: one 2.5 mm hole.
Magnet 14 mm
Magnetic snap: two 1.5 mm holes for its prongs, 9 mm apart.
Magnet 18 mm
Magnetic snap: two 1.5 mm holes for its prongs, 12 mm apart.
Chicago screw
About 9 mm head: one 4 mm hole.
Eyelet
5 mm bore: one 5 mm hole.
Buckle
Roller buckle for a 25 mm strap: one 3 mm hole for the tongue.
D-ring
20 mm, strap-mounted: a placement mark, no holes.
Zipper end
A placement mark for a zip’s end stop, no holes.

Move it with its part

Drag hardware to move it. It does not follow a part by itself: group them, or select both, to move them together.

  • Copy, duplicate, lock, mirror and delete it like a part. A linked mirror mirrors its hardware too.
  • It is printed at real size, with the holes filled in to show where to punch.
  • It is listed in the Layers list, where you can rename it.

Something missing or unclear? Write to support@easypatt.com and it gets fixed.