1. Help
  2. Leather features

Lining up holes between parts

When two parts are sewn together, their holes must meet. EasyPatt lets you slide a row along its edge until its holes land on the other part’s.

Slide a row onto another

  1. Lay one part over the other where they are sewn, for example a pocket on its panel. Put the pocket on a layer above.
  2. Click the pocket’s stitch line to open it.
  3. Drag one of its holes along the row. It snaps onto a hole of the row underneath, and the whole row slides with it.
  • A hole, or the middle between two holes, also snaps onto a line that crosses the row, such as a fold line or the edge of another part.
  • Hold Shift to slide freely, without snapping.
  • On a closed row the whole ring of holes turns, so holes can leave the corners.

Only rows on visible layers attract holes.

Shorten a row

An open row has a small blue arrow at each end while it is open. Drag an arrow to shorten the row from that end, for example to stop the stitching where a strap starts.

Compare two seams

  • Give both parts the same spacing and mode.
  • Compare the numbers on the sides: they show the stitches each side gets. Click one to see the stitched lengths instead.
  • Use Fitting to make a side a whole number of stitches long, so its holes land evenly on both parts.

For a left and right piece, or a front and back, draw one and make the other a linked mirror: its holes are mirrored exactly and stay that way.

Something missing or unclear? Write to support@easypatt.com and it gets fixed.