1. Help
  2. Drawing

Exact sizes, sums and variables

Every size in the panel can be typed. A box also takes a sum, a size in another unit, or the name of a variable you set once for the whole project.

Type a size

Click a box, type the number and press Enter, or click away. A plain number is in the project’s unit, shown at the bottom of the left panel: mm, cm or in. Switch it there; every size, label and printed measurement follows.

Stitch spacing, hole sizes and the stitch insets stay in millimetres in every unit, as chisels are sized.

Sums and units

A box can work a sum out for you:

100/3
A third of 100: the width of three equal pockets.
2*25.4
Two inches, in millimetres.
85.6 + 2*3
A card’s width plus 3 mm on each side.
5 cm
A size in another unit. mm, cm and in all work.

Use +, −, *, / and brackets. Write decimals with a point, not a comma. A number in a sum with no unit after it counts as millimetres.

Variables

A variable is a size with a name, such as card_height = 60. Set it once and use its name in any size box: change the variable and every size that uses it follows.

  1. Open the Variables tab in the left panel and click + Variable.
  2. Type a name (letters, digits and _, no spaces) and its value. The value can be a sum, and can use other variables.
  3. In a size box, type the name, or a sum with it such as card_height + 8. Or click fx in the box and pick the variable.

A few boxes keep only the result of the sum, not the sum: the width and height of a rectangle, the length of a line, the size of a triangle, the side length of a polygon, and the Edge boxes. Those do not change when the variable does.

Renaming or deleting a variable does not change the boxes that use it. Change those too, or they count as 0.

Something missing or unclear? Write to support@easypatt.com and it gets fixed.