1. Help
  2. Wallet Builder

How the wallets are built

The Builder follows the construction leather makers use for each wallet. Knowing it helps you read the pattern and choose the settings.

Pocket stacks

  • The front pocket of a stack is a whole piece. Each pocket behind it shows as a band above the next one’s mouth and is cut away in a V below that band, so the seams stay thin.
  • The bottom of each V is a row of stitching of its own, through the layers behind it.
  • Pocket pieces are about as tall as the front pocket, so several pieces often share one pattern: the Parts tab says how many to cut.
  • A pocket is never taller than a card plus 10 mm, and never shorter than 20 mm.

Card holder

A back and a front panel, with the centre pocket between them and a stepped stack of pockets on the outside of each panel. It is stitched up both sides and along the bottom; the top stays open.

Bifold and trifold

  • The outer shell and the inner shell are each one piece across the folds. A liner, if you add one, is glued to the outer shell.
  • Bills go between the inner shell and what is outside it.
  • Pockets stop 4 mm short of every fold, and the folds stay free of stitching.
  • Where a stack meets the wallet’s edge, and along the bottom, the stitching goes through every layer. Toward a fold it goes through the inner shell and the pockets only.
  • The outer shell is cut longer at each fold by the fold allowance, so it reaches round the inside when the wallet closes.

A trifold’s left panel closes first and is cut 2 mm narrower, so its edge sits inside the right panel’s fold. The right panel closes last, over it.

Long wallet

  • Each pocket is one piece across the wallet, divided into card slots by rows of stitching.
  • The pockets open toward the outer long edge, away from the fold, and sit on a pocket panel stitched up the two short sides and along that edge.
  • Bills go behind the pocket panel and lie the whole length of the wallet, opening at the fold.

It starts with pockets on the upper half only. Click + under Lower to give the lower half the same ones.

When cards stand up

A bank card lies across a pocket when there is at least 86.6 mm between the stitching on its sides. In a narrower pocket the card stands on its short side instead, and the pocket can then be cut up to 95.6 mm tall. The default trifold and a long wallet with three slots across are like this.

A pocket too narrow for a card even standing, or one that would leave a card sticking out more than 1 mm past the wallet’s edge, gets no card in 3D and is listed as too narrow or too short.

Something missing or unclear? Write to support@easypatt.com and it gets fixed.